If you have the nothing ear (1) earbuds and want to pair or connect to iPhone and iPad? Nothing ear (1) With its 11,6mm dynamic driver, Hybrid Active Noise Cancellation, 3 high definition microphones, AI-powered Environmental Noise Cancellation, 34 hours of battery life when using the charging case, IPX4 dust and sweat resistance certification, Bluetooth 5.2, and other features, the Nothing Ear (1) are equipped with a lot of features. Now, here we’ll show you how to pair or connect Nothing ear 1 to iPhone and iPad.
How to Pair Nothing ear 1 with your iPhone
So, now connect Nothing ear 1 to iPhone and iPads, in simple steps.
Step 1. Go to the Bluetooth setting app on your iPhone.
Step 2. Turn on the Bluetooth.

Bluetooth
Step 3. Now, open the lid of the charging case, and press and hold the multifunction touch button on its side for 2 seconds. after that, the earbuds will turn on automatically.
Step 4. Select the Nothing ear (1). If a password is needed, type “0000“.

Nothing ear (1)
Finally; you have successfully paired your Nothing Ear 1 earbuds with your iPhone.
Disconnect the Nothing Earbuds from your iPhone
If want to unpair the nothing ear (1) from iPhone, it’s two easy methods to disconnect it.
- When the nothing earbuds are connected to the iPhone, will have the option to remove or disconnect the earbuds. Tap to Disconnect Nothing ear (1) or forget This Device.

Disconnect
- Place the earbuds into the charging case. After that, the earbuds will turn off automatically.

turn off
How to Control and Operate the Nothing Ear (1) Earbuds
- Play or pause music: Press the multifunction touch button on any of the earbuds two times.
- Turn the volume up Press and swipe up the multifunction touch button on any of the earbuds.
- Turn the volume down Press and swipe down the multifunction touch button on any of the earbuds.
- Play the next song: Press the multifunction touch button on the right earbud three times.
- Play the previous song: Press the multifunction touch button on the left earbud three times.
- Answer an incoming call: Press the multifunction touch button on any of the earbuds two times.
- End a current call: Press and hold the multifunction touch button on any of the earbuds.
- Reject an incoming call: Press and hold the multifunction touch button on any of the earbuds for two seconds.
Nothing Ear (1) Manual Enable Mono Mode
You only need to pair the earbuds with the iPhone and remove one from the charging case to turn on or off the mono mode in the Nothing Ear (1). It will begin operating on its own.
Finally; that is all about pairing or connecting nothing ear (1) to iPhone and iPad, unpairing the Nothing ear (1), and activating mono mode.
More: